Shure PGXD14-X8 PGX-D Series Single-Channel Digital Wireless Bodypack System With WA302 Instrument Cable
The PGXD14 Bodypack Wireless System is part of the PGX-D wireless systems family. It includes a PGXD4 receiver, PGXD1 bodypack transmitter, guitar cable, power supply, 2 AA batteries, carrying case, and user guide. PGX-D Digital Wireless, with state-of-the-art, 24-bit digital audio and trusted Shure microphones, delivers stunning sound and a strong, clean RF signal. Slim, compact bodypack with belt clip features power, mute, and battery status LEDs; recessed dial with 26 dB of adjustable gain, and lockable interface that prevents accidental setting change.
Includes- PGXD4 wireless receiver
- PGXD1 bodypack transmitter
- WA302 instrument cable
- Power supply
- 2 AA batteries
- Carrying case
- User guide
- 200' operating range
- 24-bit/48kHz digital technology for incredibly accurate sound
- Automatic frequency selection
- One-touch sync
- 26dB of adjustable gain
- Operating Range: 200ft (60m) under typical conditions.
- Note: actual range depends on RF signal absorption, reflection, and interference.
- RF Carrier Range:
- X8: 902–928 MHz
- Audio Frequency Response (± 2 dB): 20-20,000 MHz
- System Gain:
- PGXD1: -54.5 dBV/Pa at -10dB gain setting, with SM58 catridge, XLR output
- Total Harmonic Distortion: < 0.02%, A-weighted, typical (Ref. 1 kHz, 6dB below input clip)
- Dynamic Range: >108 dB A-weighted
- Operating Temperature Range: 0°F (-18°C) to +122°F (+50°C).
- Note: battery characteristics may limit this range.
- Shure PGXD1 Bodypack:
- Audio Input Level: +10 dBV maximum, at minimum gain setting
- -16 dBVmaximum, at maximum gain setting
- Gain Adjustment Range: 26 dB
- Input Impedance: 1 M Ohm
- RF Output Level: 10 mW maximum (dependent on applicable country regulations)
- Dimensions (HxWxD): 4.25" x 2.50" x 0.75" (108 x 64 x 19mm)
- Weight: 4.5 oz (128 g) without batteries
- Housing: Molded polycarbonate case
- Power Requirements: 2 “AA” size
- Battery Life: Up to 10 hours
- Shure PGXD4 Wireless Receiver:
- Dimensions (HxWxD): 1.6" x 7.125" x 4.1" (40 x 181 x 104mm)
- Weight: 10.2 oz (289 g)
- Housing: ABS
- Audio Output Level (ref. ± 38 kHz deviation, 1 kHz tone):
- XLR connector (into 3,000-Ohm load): -2.5 dBV
- 1/4" connector (into 10,000-Ohm load): +10 dBV
- Impedance:
- XLR: 50 Ohms
- ¼": 50 Ohms
- Sensitivity: -102 dBm @ 10-5 BER
- Image Rejection: > 70 dB, typical
- XLR output (impedance balanced):
- Pin 1: Ground (cable shield)
- Pin 2: Audio
- Pin 3: No Audio
- Audio LED:
- Red: 2 dB below clip
- Amber: 12 dB below clip
- Green: 50 dBbelow clip
- Power Requirements: 12-18 VDC at150 mA, supplied by external power supply
- Pin Assignments: XLR: 1=ground, 2=hot, 3=cold, ¼" (6.35mm) TRS: Tip=audio, Ring=no audio, Sleeve=ground